APRS Track Direct

My position About ☰

reset

SQ9SIM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9SIM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1782499397	876 Count	379 Count	379 Count
1782495814	874 Count	379 Count	379 Count
1782492212	872 Count	379 Count	379 Count
1782488610	870 Count	379 Count	379 Count
1782485009	868 Count	379 Count	379 Count
1782481407	866 Count	379 Count	379 Count
1782477805	860 Count	375 Count	375 Count
1782474204	854 Count	371 Count	371 Count
1782470602	842 Count	361 Count	361 Count
1782467001	840 Count	361 Count	361 Count
1782463399	838 Count	361 Count	361 Count
1782459798	836 Count	361 Count	361 Count
1782456196	834 Count	361 Count	361 Count
1782452613	827 Count	356 Count	356 Count
1782449011	819 Count	350 Count	350 Count
1782445410	817 Count	350 Count	350 Count
1782441808	815 Count	350 Count	350 Count
1782438206	813 Count	350 Count	350 Count
1782434605	811 Count	350 Count	350 Count
1782431003	809 Count	350 Count	350 Count
1782427402	807 Count	350 Count	350 Count
1782423800	805 Count	350 Count	350 Count
1782420199	803 Count	350 Count	350 Count
1782416597	801 Count	350 Count	350 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)