APRS Track Direct

My position About ☰

reset

ED1ZAE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED1ZAE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732301072	52	24	85	175	147
1732301072	52	24	85	175	147
1732299872	52	23	85	175	148
1732299272	51	23	85	175	149
1732298672	50	21	85	175	149
1732297472	47	21	85	176	149
1732297472	47	21	85	176	149
1732296272	41	17	85	175	150
1732295672	40	17	85	175	149
1732295072	39	17	85	175	150
1732293872	40	17	85	176	152
1732293872	40	17	85	176	152
1732292672	39	18	85	176	153
1732292072	38	18	85	176	154
1732291472	39	18	85	176	154
1732290273	37	17	85	172	155
1732290272	37	17	85	172	155
1732289072	37	17	85	175	156
1732288473	37	16	85	175	156
1732287872	37	16	85	175	156
1732286673	36	16	85	175	156
1732286672	36	16	85	175	156
1732285472	35	16	85	175	157
1732284873	35	16	85	175	157
1732284272	36	17	85	175	157

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)