APRS Track Direct

My position About ☰

reset

SR9EMP Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1763229978	92 Count	963 Count	88 Count
1763228177	76 Count	754 Count	73 Count
1763226377	56 Count	551 Count	54 Count
1763224576	40 Count	361 Count	39 Count
1763222775	17 Count	177 Count	17 Count
1763220974	120 Count	1086 Count	115 Count
1763219174	100 Count	832 Count	96 Count
1763217383	70 Count	603 Count	67 Count
1763215582	41 Count	390 Count	39 Count
1763213781	17 Count	210 Count	17 Count
1763211980	119 Count	1011 Count	114 Count
1763210180	93 Count	804 Count	89 Count
1763208379	73 Count	650 Count	70 Count
1763206578	54 Count	500 Count	52 Count
1763204777	35 Count	350 Count	34 Count
1763202976	18 Count	188 Count	18 Count
1763201175	120 Count	1187 Count	114 Count
1763199374	104 Count	992 Count	99 Count
1763197573	87 Count	811 Count	83 Count
1763195781	59 Count	584 Count	57 Count
1763193980	35 Count	343 Count	34 Count
1763192179	14 Count	179 Count	14 Count
1763190379	95 Count	1047 Count	91 Count
1763188578	77 Count	852 Count	74 Count
1763186777	54 Count	489 Count	52 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)