APRS Track Direct

My position About ☰

reset

OK1XRV-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1XRV-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790659015	153	171	150	124	123
1790657551	153	171	150	119	122
1790655355	153	171	150	124	123
1790654623	153	171	150	122	123
1790652793	153	171	150	124	123
1790651695	153	171	150	121	123
1790650963	153	171	150	124	123
1790650231	153	171	150	124	123
1790649865	153	171	150	124	123
1790646937	153	171	150	125	123
1790646571	153	171	150	125	124
1790646205	153	171	150	122	123
1790644375	153	171	150	125	124
1790644009	153	171	150	125	124
1790642911	153	171	150	122	123
1790642545	153	171	150	125	124
1790641447	153	171	150	125	124
1790641081	153	171	150	125	124
1790640348	153	171	150	122	124
1790638153	153	171	150	125	124
1790637420	153	171	150	122	124
1790637054	153	171	150	122	124
1790636323	153	171	150	125	124
1790635957	153	171	150	125	124
1790634858	153	171	150	123	124

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)