APRS Track Direct

My position About ☰

reset

YH4MC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YH4MC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1836274576	-61 dBm	19.07 V
1836274469	-56 dBm	18.42 V
1836274251	-57 dBm	16.92 V
1836274155	-64 dBm	18.74 V
1836273928	-54 dBm	16.67 V
1770486124	-36 dBm	0.57 V
1770485801	-35 dBm	0.53 V
1770485478	-36 dBm	0.57 V
1770485155	-36 dBm	0.51 V
1770484833	-37 dBm	0.59 V
1770484510	-35 dBm	0.55 V
1770484188	-37 dBm	0.57 V
1770483865	-36 dBm	0.53 V
1770483542	-34 dBm	17.14 V
1770483220	-35 dBm	17.14 V
1770482897	-37 dBm	17.17 V
1770482575	-36 dBm	17.14 V
1770482252	-37 dBm	17.12 V
1770481930	-37 dBm	17.12 V
1770481607	-36 dBm	17.19 V
1770481284	-35 dBm	17.23 V
1770480961	-36 dBm	17.23 V
1770480638	-34 dBm	17.23 V
1770480315	-37 dBm	17.23 V
1770479992	-36 dBm	17.23 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)