APRS Track Direct

My position About ☰

reset

N1CJL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N1CJL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1763657944	141	74	129	114	99
1763657044	141	73	129	115	100
1763655245	141	71	129	114	100
1763654346	141	71	128	114	99
1763653446	141	76	130	115	100
1763652547	141	73	129	115	100
1763651645	141	69	129	116	101
1763650746	141	68	130	116	102
1763648047	141	66	129	116	102
1763647147	141	65	130	117	103
1763646248	141	64	131	119	105
1763645348	141	62	134	124	110
1763608267	141	78	129	114	99
1763607367	141	78	129	115	100
1763606466	141	78	129	114	99
1763605567	141	79	129	114	99
1763604666	141	79	130	115	100
1763602866	141	78	130	115	100
1763601967	141	78	130	115	100
1763601067	141	77	129	114	99
1763600167	141	76	129	114	99
1763599266	141	78	130	115	101
1763598367	141	78	129	112	98
1763597466	141	78	129	112	98
1763596566	141	76	129	112	97

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)