APRS Track Direct

My position About ☰

reset

PVLY Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PVLY. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274455	160	96	19	72	118
1836274300	161	97	20	72	118
1782517466	200	106	26	71	103
1782516559	201	103	26	70	122
1782515649	200	102	26	71	123
1782514749	198	99	25	72	124
1782513848	196	100	26	75	124
1782512947	191	96	24	74	124
1782512046	184	89	23	73	103
1782511145	173	85	23	69	101
1782510244	165	77	22	67	123
1782509344	162	70	20	66	125
1782508448	161	72	21	65	125
1782507542	171	78	21	68	104
1782506641	181	87	22	69	123
1782505740	188	104	26	70	123
1782504844	196	117	29	72	103
1782503938	201	127	31	73	124
1782503037	199	134	32	74	123
1782502160	198	132	32	74	124
1782501236	195	127	30	74	124
1782500345	192	131	31	75	124
1782499434	188	129	30	76	106
1782498533	186	132	29	77	103
1782497634	183	132	29	79	125

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)