APRS Track Direct

My position About ☰

reset

KC9YTT-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC9YTT-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1770142232	120	78	255	119	81
1770141029	120	78	255	119	81
1770138626	120	78	255	119	81
1770136222	120	78	255	119	82
1770132617	120	78	255	119	82
1770131415	120	78	255	119	82
1770129012	120	78	255	119	81
1770127810	120	78	255	119	81
1770126608	120	78	255	119	82
1770125406	120	78	255	119	81
1770124204	120	78	255	119	81
1770123003	120	78	255	119	81
1770121801	120	77	255	119	82
1770119397	120	77	255	119	82
1770118196	120	77	255	119	81
1770113389	120	77	255	119	82
1770110985	120	77	255	119	81
1770109783	120	77	255	119	82
1770106178	120	78	255	119	81
1770104976	120	77	255	119	82
1770103774	120	77	255	119	81
1770102572	120	77	255	119	82
1770101370	120	77	255	119	82
1770094159	120	77	255	119	82
1770090554	120	78	255	119	81

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)