APRS Track Direct

My position About ☰

reset

ELKPNT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ELKPNT. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value4*
1786754919	153	174	139
1786754318	153	174	139
1786753716	153	174	139
1786753115	152	174	139
1786752514	153	174	139
1786751912	153	174	139
1786751311	153	174	139
1786750710	153	174	139
1786750108	153	174	139
1786749507	152	174	139
1786748906	153	174	139
1786748304	153	174	139
1786747102	152	174	139
1786746500	153	174	139
1786745899	153	174	139
1786745298	153	174	139
1786744696	153	174	139
1786744095	153	173	139
1786743493	152	174	139
1786742892	152	173	139
1786742291	152	174	139
1786741690	152	174	139
1786741088	151	174	139
1786740487	152	173	139
1786739886	152	174	139

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)