APRS Track Direct

My position About ☰

reset

S51ZK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object S51ZK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1762312661	112 Count	662 Count	102 Count
1762309058	102 Count	601 Count	93 Count
1762305455	91 Count	542 Count	83 Count
1762301852	80 Count	480 Count	73 Count
1762298249	69 Count	415 Count	63 Count
1762294664	58 Count	347 Count	53 Count
1762291061	45 Count	287 Count	41 Count
1762287458	34 Count	219 Count	31 Count
1762283855	22 Count	139 Count	20 Count
1762280251	11 Count	72 Count	10 Count
1762276648	0 Count	0 Count	0 Count
1762273063	140 Count	991 Count	127 Count
1762269460	129 Count	931 Count	117 Count
1762265857	119 Count	871 Count	108 Count
1762262253	108 Count	816 Count	98 Count
1762258650	99 Count	760 Count	90 Count
1762255050	88 Count	661 Count	80 Count
1762251464	79 Count	572 Count	72 Count
1762247861	65 Count	491 Count	59 Count
1762244258	52 Count	429 Count	47 Count
1762240654	43 Count	356 Count	39 Count
1762237051	38 Count	298 Count	35 Count
1762233448	30 Count	209 Count	28 Count
1762229862	19 Count	141 Count	18 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)