APRS Track Direct

My position About ☰

reset

W1BST Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W1BST. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786720095	128	82	127	107	95
1786718297	130	81	127	106	93
1786716498	128	79	126	106	94
1786712902	137	79	126	107	95
1786707508	138	78	126	107	95
1786703911	138	78	125	106	94
1786700313	138	78	127	107	95
1786689524	138	80	127	106	94
1786687723	138	80	127	107	94
1786684126	138	80	126	107	94
1786682328	138	80	126	106	94
1786680529	138	80	126	106	94
1786678731	138	80	126	106	94
1786675135	138	81	125	106	94
1786673337	138	81	126	106	93
1786667943	138	80	126	106	93
1786666145	138	80	126	105	93
1786664347	138	81	127	107	94
1786662549	138	82	127	107	94
1786660751	124	82	126	106	94
1786658952	138	83	126	105	93
1786655354	138	85	126	105	92
1786646364	138	86	127	106	92
1786644566	138	85	127	106	93
1786639171	138	84	126	105	92

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)