APRS Track Direct

My position About ☰

reset

SK3VJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SK3VJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786732848	89 Count	357 Count	79 Count
1786731045	79 Count	316 Count	70 Count
1786729242	64 Count	272 Count	56 Count
1786727440	53 Count	231 Count	46 Count
1786725670	37 Count	162 Count	35 Count
1786723867	28 Count	101 Count	27 Count
1786722064	13 Count	58 Count	13 Count
1786720261	280 Count	1023 Count	252 Count
1786718458	268 Count	940 Count	241 Count
1786716655	258 Count	857 Count	232 Count
1786714852	244 Count	816 Count	219 Count
1786713049	232 Count	775 Count	208 Count
1786711246	216 Count	726 Count	193 Count
1786709443	204 Count	687 Count	182 Count
1786707639	191 Count	639 Count	170 Count
1786705837	176 Count	598 Count	156 Count
1786704067	155 Count	544 Count	140 Count
1786702264	144 Count	487 Count	130 Count
1786698658	115 Count	398 Count	103 Count
1786696855	101 Count	345 Count	90 Count
1786695052	91 Count	296 Count	81 Count
1786693249	77 Count	249 Count	68 Count
1786691447	62 Count	203 Count	54 Count
1786689643	48 Count	151 Count	41 Count
1786687840	34 Count	96 Count	28 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)