APRS Track Direct

My position About ☰

reset

SP9APJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9APJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770397041	147 Count	1009 Count	113 Count
1770395240	133 Count	970 Count	100 Count
1770393439	126 Count	938 Count	94 Count
1770391639	118 Count	900 Count	87 Count
1770389838	114 Count	871 Count	84 Count
1770388038	110 Count	844 Count	81 Count
1770386237	106 Count	810 Count	78 Count
1770384436	102 Count	785 Count	75 Count
1770382636	98 Count	750 Count	72 Count
1770380835	94 Count	724 Count	69 Count
1770379041	86 Count	692 Count	66 Count
1770377240	81 Count	637 Count	62 Count
1770375440	75 Count	584 Count	57 Count
1770373639	70 Count	552 Count	53 Count
1770371838	66 Count	524 Count	50 Count
1770370038	59 Count	482 Count	44 Count
1770368237	56 Count	427 Count	42 Count
1770366436	50 Count	380 Count	37 Count
1770364636	43 Count	323 Count	31 Count
1770362835	38 Count	287 Count	27 Count
1770361035	34 Count	255 Count	24 Count
1770359234	30 Count	216 Count	21 Count
1770357440	22 Count	185 Count	18 Count
1770355639	18 Count	145 Count	15 Count
1770353839	14 Count	102 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)