APRS Track Direct

My position About ☰

reset

VA7OGO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VA7OGO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790636976	133	44	103	41	49
1790635175	133	30	74	41	49
1790629770	137	32	72	42	48
1790627963	138	28	74	41	48
1790624358	139	28	73	41	49
1790622555	140	29	74	42	49
1790620749	140	31	74	41	49
1790618948	143	36	74	41	49
1790613537	145	30	76	66	50
1790611737	136	33	76	41	75
1790609930	134	30	76	41	49
1790608129	130	32	77	41	49
1790606329	127	29	77	41	49
1790602719	126	30	77	41	49
1790599114	126	23	77	41	49
1790597312	126	29	77	40	49
1790593709	126	34	77	41	48
1790591905	126	32	76	41	49
1790590106	126	35	76	41	49
1790588303	126	29	77	40	49
1790586498	126	26	77	41	49
1790584697	127	25	106	41	49
1790579286	127	22	77	41	49
1790577484	127	27	76	41	49
1790575680	127	28	77	41	49

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)