APRS Track Direct

My position About ☰

reset

IZ5DIY-30 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ5DIY-30. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Volt*	Ampere*
1774085075	12.5 V	-1 A
1774083260	12.4 V	-2 A
1774079625	12.3 V	-1 A
1774075995	12.4 V	-1 A
1774074182	12.3 V	-2 A
1774068725	12.4 V	-2 A
1774066914	12.4 V	-1 A
1774065096	12.4 V	-1 A
1774061465	12.4 V	-1 A
1774059650	12.4 V	-1 A
1774056020	12.4 V	-1 A
1774054199	12.4 V	-1 A
1774050573	12.5 V	-1 A
1774046939	12.5 V	-1 A
1774045124	12.5 V	-2 A
1774043308	12.5 V	-1 A
1774041499	12.5 V	-2 A
1774037869	12.6 V	-2 A
1774034243	12.6 V	-2 A
1774032428	12.6 V	-2 A
1774028794	12.7 V	-2 A
1774026976	12.7 V	-2 A
1774017903	13.1 V	-2 A

*Used Equation Coefficients:

Volt: 0, 1, 0

Ampere: 0, 1, 0

Batt: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)