APRS Track Direct

My position About ☰

reset

SP5RT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5RT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762290194	381 Count	737 Count	272 Count
1762289593	378 Count	734 Count	270 Count
1762287791	369 Count	722 Count	264 Count
1762286589	363 Count	710 Count	260 Count
1762285989	360 Count	702 Count	258 Count
1762285388	356 Count	695 Count	255 Count
1762284789	354 Count	692 Count	254 Count
1762284187	352 Count	687 Count	253 Count
1762283586	347 Count	677 Count	249 Count
1762283299	342 Count	677 Count	249 Count
1762282699	337 Count	660 Count	247 Count
1762282098	332 Count	647 Count	243 Count
1762281497	328 Count	633 Count	240 Count
1762280897	325 Count	622 Count	238 Count
1762280296	320 Count	606 Count	234 Count
1762279696	315 Count	589 Count	230 Count
1762279095	312 Count	574 Count	228 Count
1762278495	307 Count	560 Count	224 Count
1762277894	304 Count	543 Count	222 Count
1762277293	296 Count	519 Count	219 Count
1762276693	289 Count	502 Count	214 Count
1762276092	281 Count	479 Count	207 Count
1762275492	278 Count	463 Count	205 Count
1762274990	269 Count	452 Count	201 Count
1762274389	265 Count	434 Count	198 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)