APRS Track Direct

My position About ☰

reset

SP6TK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1750121036	352 Count	235 Count	18 Count
1750119835	344 Count	225 Count	17 Count
1750118634	325 Count	219 Count	17 Count
1750117433	307 Count	211 Count	16 Count
1750116232	289 Count	203 Count	15 Count
1750115032	267 Count	197 Count	15 Count
1750113831	247 Count	190 Count	14 Count
1750112630	224 Count	180 Count	13 Count
1750111429	212 Count	175 Count	13 Count
1750110228	200 Count	168 Count	12 Count
1750087440	996 Count	355 Count	60 Count
1750086239	974 Count	348 Count	60 Count
1750085038	952 Count	341 Count	59 Count
1750083837	944 Count	332 Count	57 Count
1750082636	927 Count	328 Count	57 Count
1750081436	893 Count	300 Count	36 Count
1750080235	873 Count	295 Count	34 Count
1750079034	848 Count	287 Count	34 Count
1750077833	803 Count	278 Count	33 Count
1750076632	777 Count	271 Count	32 Count
1750075431	744 Count	267 Count	32 Count
1750074231	726 Count	259 Count	31 Count
1750073030	712 Count	251 Count	30 Count
1750071829	694 Count	245 Count	30 Count
1750070628	676 Count	237 Count	29 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)