APRS Track Direct

My position About ☰

reset

SQ3KT-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3KT-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762285839	32 Count	72 Count	19 Count
1762285083	27 Count	70 Count	19 Count
1762283282	22 Count	58 Count	15 Count
1762281482	17 Count	40 Count	11 Count
1762279685	12 Count	23 Count	7 Count
1762277880	8 Count	13 Count	4 Count
1762276076	731 Count	1029 Count	517 Count
1762274275	727 Count	987 Count	514 Count
1762272473	722 Count	942 Count	510 Count
1762270673	717 Count	935 Count	506 Count
1762268872	712 Count	928 Count	502 Count
1762267071	707 Count	921 Count	498 Count
1762265271	702 Count	915 Count	494 Count
1762263470	697 Count	908 Count	490 Count
1762261674	692 Count	896 Count	486 Count
1762259869	687 Count	886 Count	482 Count
1762258068	682 Count	876 Count	478 Count
1762256267	677 Count	863 Count	474 Count
1762254478	668 Count	854 Count	470 Count
1762252673	663 Count	846 Count	466 Count
1762250872	658 Count	841 Count	462 Count
1762249072	654 Count	837 Count	459 Count
1762247271	649 Count	832 Count	455 Count
1762245471	644 Count	827 Count	451 Count
1762243670	639 Count	822 Count	447 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)