APRS Track Direct

My position About ☰

reset

PU5SZN-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PU5SZN-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1754585086	133	255	76	55	53
1754584485	133	255	76	55	54
1754583883	134	255	76	56	54
1754583282	133	255	77	56	54
1754582681	133	255	77	56	54
1754582080	133	255	77	56	54
1754581481	134	255	77	56	54
1754580878	133	255	77	57	55
1754580277	134	255	78	57	55
1754579677	134	255	78	58	56
1754579075	136	255	78	57	55
1754577870	137	255	77	56	54
1754576669	137	255	78	57	55
1754575465	137	255	78	57	55
1754574863	137	255	78	57	55
1754574262	137	255	78	57	55
1754573662	137	255	78	57	55
1754571866	134	255	79	59	57
1754571265	133	255	79	58	56
1754570661	131	255	80	59	57
1754570051	128	255	80	60	58
1754568847	129	255	79	59	57
1754568244	130	255	80	60	58
1754567644	128	255	81	60	58
1754567038	107	255	81	61	59

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)