APRS Track Direct

My position About ☰

reset

SR8ULZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8ULZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786737864	157 Count	845 Count	70 Count
1786736064	155 Count	844 Count	69 Count
1786734263	153 Count	843 Count	68 Count
1786732462	151 Count	842 Count	67 Count
1786730669	145 Count	841 Count	66 Count
1786728868	143 Count	840 Count	65 Count
1786727067	141 Count	839 Count	64 Count
1786725267	139 Count	838 Count	63 Count
1786723466	137 Count	837 Count	62 Count
1786721665	135 Count	836 Count	61 Count
1786719865	133 Count	835 Count	60 Count
1786718064	131 Count	834 Count	59 Count
1786716263	130 Count	834 Count	59 Count
1786714463	128 Count	833 Count	58 Count
1786712662	127 Count	833 Count	58 Count
1786710862	125 Count	832 Count	57 Count
1786709068	119 Count	831 Count	56 Count
1786707268	117 Count	830 Count	55 Count
1786705466	115 Count	829 Count	54 Count
1786703666	113 Count	828 Count	53 Count
1786701865	111 Count	827 Count	52 Count
1786700064	109 Count	826 Count	51 Count
1786698264	107 Count	825 Count	50 Count
1786696463	106 Count	825 Count	50 Count
1786694662	104 Count	824 Count	49 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)