APRS Track Direct

My position About ☰

reset

TYLRPK Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TYLRPK. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274255	126	29	76	41	49
1774130968	141	26	63	41	49
1774129769	141	25	67	41	49
1774128570	141	27	64	41	49
1774127372	142	29	68	41	49
1774126172	141	31	71	41	49
1774124972	141	25	68	41	49
1774123774	141	31	70	41	49
1774122575	140	30	112	42	87
1774121376	141	29	67	49	50
1774120177	140	30	66	41	49
1774118978	142	29	70	41	49
1774117776	141	29	70	42	49
1774116578	142	28	64	41	49
1774115378	139	30	65	41	49
1774114180	141	26	65	41	49
1774112981	140	28	64	41	49
1774111783	141	29	116	42	49
1774110584	139	29	70	41	49
1774109386	133	29	77	41	49
1774108186	122	29	74	41	49
1774106988	122	28	78	41	49
1774105791	122	27	77	41	49
1774104592	122	25	127	42	48
1774103393	122	25	76	66	49

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)