APRS Track Direct

My position About ☰

reset

SP8HDC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8HDC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770126490	401 Count	176 Count	175 Count
1770124696	400 Count	176 Count	175 Count
1770122896	388 Count	165 Count	164 Count
1770121095	387 Count	165 Count	164 Count
1770119294	386 Count	165 Count	164 Count
1770117494	375 Count	155 Count	154 Count
1770115693	374 Count	155 Count	154 Count
1770113892	373 Count	155 Count	154 Count
1770112091	372 Count	155 Count	154 Count
1770110291	371 Count	155 Count	154 Count
1770108490	370 Count	155 Count	154 Count
1770106689	369 Count	155 Count	154 Count
1770104889	368 Count	155 Count	154 Count
1770103096	367 Count	155 Count	154 Count
1770101295	366 Count	155 Count	154 Count
1770099494	352 Count	142 Count	141 Count
1770097693	351 Count	142 Count	141 Count
1770095893	350 Count	142 Count	141 Count
1770094092	349 Count	142 Count	141 Count
1770092291	348 Count	142 Count	141 Count
1770090491	347 Count	142 Count	141 Count
1770088690	346 Count	142 Count	141 Count
1770086889	345 Count	142 Count	141 Count
1770085089	344 Count	142 Count	141 Count
1770083288	343 Count	142 Count	141 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)