APRS Track Direct

My position About ☰

reset

SQ8XY-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8XY-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770149146	64 Count	29 Count	29 Count
1770147345	63 Count	29 Count	29 Count
1770145545	62 Count	29 Count	29 Count
1770143744	61 Count	29 Count	29 Count
1770141944	60 Count	29 Count	29 Count
1770140143	59 Count	29 Count	29 Count
1770138342	58 Count	29 Count	29 Count
1770136541	57 Count	29 Count	29 Count
1770134750	56 Count	29 Count	29 Count
1770132949	55 Count	29 Count	29 Count
1770131148	44 Count	19 Count	19 Count
1770129348	41 Count	17 Count	17 Count
1770127547	39 Count	16 Count	16 Count
1770125746	38 Count	16 Count	16 Count
1770123946	37 Count	16 Count	16 Count
1770122145	36 Count	16 Count	16 Count
1770120344	35 Count	16 Count	16 Count
1770118543	33 Count	15 Count	15 Count
1770116743	31 Count	14 Count	14 Count
1770114942	30 Count	14 Count	14 Count
1770113149	29 Count	14 Count	14 Count
1770111349	28 Count	14 Count	14 Count
1770109548	27 Count	14 Count	14 Count
1770107747	26 Count	14 Count	14 Count
1770105946	25 Count	14 Count	14 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)