APRS Track Direct

My position About ☰

reset

SQ3KT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3KT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762270421	181 Count	927 Count	113 Count
1762269521	179 Count	913 Count	112 Count
1762268620	176 Count	902 Count	110 Count
1762267719	174 Count	889 Count	109 Count
1762266818	171 Count	872 Count	107 Count
1762265918	169 Count	858 Count	106 Count
1762265016	166 Count	847 Count	104 Count
1762264115	164 Count	830 Count	103 Count
1762263215	161 Count	803 Count	101 Count
1762262314	159 Count	785 Count	100 Count
1762261413	156 Count	775 Count	98 Count
1762260512	154 Count	764 Count	97 Count
1762259614	151 Count	749 Count	95 Count
1762258713	149 Count	737 Count	94 Count
1762257812	146 Count	728 Count	92 Count
1762256911	144 Count	717 Count	91 Count
1762256010	137 Count	694 Count	85 Count
1762255109	135 Count	674 Count	84 Count
1762254209	133 Count	667 Count	83 Count
1762253308	131 Count	655 Count	82 Count
1762252407	128 Count	640 Count	80 Count
1762251520	126 Count	627 Count	79 Count
1762250619	123 Count	614 Count	77 Count
1762249718	121 Count	589 Count	76 Count
1762248817	118 Count	569 Count	74 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)