APRS Track Direct

My position About ☰

reset

VK4RSM-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK4RSM-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value4*	Value5*
1836274383	136	73	37	49
1836273934	142	73	37	49
1774153644	133	87	32	42
1774152445	131	89	32	42
1774151246	130	89	31	41
1774150043	130	91	31	41
1774148846	130	92	31	40
1774147645	130	93	30	40
1774146442	133	93	30	40
1774145243	144	93	30	40
1774144044	138	93	30	40
1774142845	139	92	31	40
1774141646	136	91	31	41
1774140447	141	90	31	41
1774139246	135	89	32	42
1774138047	139	89	32	42
1774136848	136	88	32	42
1774135645	140	85	33	43
1774134446	134	83	33	44
1774133247	132	80	34	46
1774132042	121	77	36	47
1774130843	121	75	36	48
1774129643	130	74	36	48
1774128444	128	73	37	49
1774127245	127	72	37	49

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)