APRS Track Direct

My position About ☰

reset

JA2YQQ-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object JA2YQQ-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274580	120	97	255	81	82
1836274429	120	97	255	81	82
1762336614	120	77	255	93	97
1762335714	120	77	255	93	97
1762334812	120	77	255	93	97
1762333911	120	77	255	92	96
1762333009	120	77	255	93	97
1762332109	120	77	255	92	97
1762331208	120	77	255	92	96
1762329406	120	78	255	92	96
1762328505	120	78	255	92	96
1762327604	120	78	255	92	96
1762326703	120	79	255	92	95
1762325802	120	79	255	92	95
1762324901	120	79	255	91	95
1762324000	120	80	255	91	95
1762323100	120	81	255	91	94
1762322198	120	82	255	90	94
1762321297	120	82	255	90	93
1762320396	120	82	255	89	93
1762318594	120	83	255	89	92
1762317693	120	83	255	89	92
1762316792	120	83	255	89	92
1762315891	120	82	255	89	93
1762314990	120	82	255	90	93

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)