APRS Track Direct

My position About ☰

reset

AE6PS Telemetry

This is the latest recevied telemetry packets stored in our database for station/object AE6PS. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value5*
1765939665	152	171	249	6
1765939385	152	174	251	4
1765939200	152	174	251	5
1765939038	152	174	250	5
1765939007	152	174	250	4
1765938700	152	176	250	5
1765938642	152	173	251	5
1765938554	152	174	250	5
1765938397	152	172	249	6
1765938349	152	173	250	6
1765938256	152	172	250	5
1765938049	152	173	250	5
1765937974	152	173	250	5
1765937870	152	173	250	5
1765937758	152	174	251	5
1765937493	151	175	251	5
1765935701	150	175	251	6
1765935682	150	173	250	6
1765935298	150	175	250	7
1765935040	150	174	250	8
1765934575	149	174	250	9
1765934497	149	173	251	7
1765934474	149	172	250	7
1765934436	149	171	250	7
1765934380	149	170	250	27

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)