APRS Track Direct

My position About ☰

reset

N7SHM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N7SHM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790638363	139	75	999	658	486
1790634768	139	75	999	659	489
1790631172	139	74	999	660	489
1790627577	139	75	999	660	489
1790623982	139	74	999	660	491
1790620387	139	74	999	661	490
1790616792	139	72	999	662	494
1790613196	139	71	999	664	497
1790609601	139	70	999	666	497
1790606006	139	68	999	668	500
1790602411	139	64	999	672	505
1790598816	139	64	999	671	507
1790595220	139	64	999	671	507
1790591625	139	65	999	672	506
1790584435	139	65	999	670	503
1790580840	139	66	999	670	503
1790577246	139	65	999	670	504
1790573650	139	66	999	670	503
1790570054	139	66	999	669	502
1790566459	139	66	999	670	504
1790562864	139	65	999	671	505
1790559269	139	64	999	671	505
1790555674	139	64	999	672	507

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)