APRS Track Direct

My position About ☰

reset

MB7USU-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7USU-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790642982	381 Count	379 Count	288 Count
1790641181	376 Count	374 Count	285 Count
1790639380	372 Count	370 Count	282 Count
1790637579	368 Count	366 Count	279 Count
1790635779	364 Count	361 Count	276 Count
1790633978	359 Count	356 Count	272 Count
1790632177	355 Count	352 Count	269 Count
1790630377	351 Count	348 Count	266 Count
1790628586	347 Count	344 Count	263 Count
1790626785	343 Count	340 Count	260 Count
1790623183	334 Count	332 Count	253 Count
1790619582	326 Count	325 Count	247 Count
1790617781	322 Count	321 Count	244 Count
1790614180	313 Count	313 Count	237 Count
1790606984	298 Count	301 Count	226 Count
1790605183	294 Count	295 Count	223 Count
1790603382	290 Count	292 Count	220 Count
1790601582	285 Count	288 Count	217 Count
1790599781	281 Count	284 Count	214 Count
1790597980	276 Count	279 Count	210 Count
1790596180	272 Count	275 Count	207 Count
1790594379	268 Count	271 Count	204 Count
1790592578	264 Count	267 Count	201 Count
1790590778	260 Count	263 Count	198 Count
1790588977	255 Count	258 Count	194 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)