APRS Track Direct

My position About ☰

reset

EA4CHS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4CHS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RFIn*	RFiGate*	DigiRpt*	Temp*
1762303677	79 Pkts	77 Pkts	33 Pkts	32 C
1762300077	33 Pkts	30 Pkts	17 Pkts	32 C
1762296477	49 Pkts	45 Pkts	33 Pkts	32 C
1762292877	47 Pkts	47 Pkts	27 Pkts	32 C
1762289277	51 Pkts	49 Pkts	27 Pkts	32 C
1762285676	79 Pkts	77 Pkts	32 Pkts	32 C
1762282077	201 Pkts	198 Pkts	48 Pkts	32 C
1762278476	91 Pkts	90 Pkts	35 Pkts	32 C
1762274880	127 Pkts	125 Pkts	34 Pkts	32 C
1762271277	70 Pkts	68 Pkts	33 Pkts	32 C
1762267677	43 Pkts	41 Pkts	27 Pkts	31 C
1762264077	43 Pkts	41 Pkts	33 Pkts	31 C
1762260477	50 Pkts	48 Pkts	40 Pkts	31 C
1762256877	36 Pkts	36 Pkts	25 Pkts	32 C
1762253278	39 Pkts	37 Pkts	25 Pkts	31 C

*Used Equation Coefficients:

RFIn: 0, 1, 0

RFiGate: 0, 1, 0

DigiRpt: 0, 1, 0

Temp: 0, 1, 0

InetiGate: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)