APRS Track Direct

My position About ☰

reset

CEF4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CEF4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1774146175	131	1	11	14	33
1774143675	130	1	11	14	32
1774141175	131	1	11	14	32
1774138674	131	1	11	14	32
1774136175	131	1	11	14	32
1774131174	131	1	11	15	33
1774128674	131	1	12	14	34
1774126174	131	1	11	14	34
1774123674	131	1	11	14	34
1774121174	131	1	11	14	33
1774118674	130	1	11	14	34
1774116174	130	1	11	14	34
1774113674	130	1	11	14	34
1774111174	130	1	11	14	34
1774108674	130	1	11	14	34
1774106174	130	1	11	14	34
1774103674	130	1	11	14	34
1774101174	130	1	11	14	34
1774098674	130	1	11	14	34
1774096174	130	1	11	14	33
1774093674	130	1	11	14	34
1774091173	130	1	11	14	34
1774088673	130	1	11	14	34
1774086173	130	1	11	14	34
1774083673	130	1	11	14	33

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)