APRS Track Direct

My position About ☰

reset

SP2GK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1762297908	357 Count	42 Count
1762296108	356 Count	42 Count
1762294307	355 Count	42 Count
1762292506	354 Count	42 Count
1762290705	353 Count	42 Count
1762288904	352 Count	42 Count
1762287104	351 Count	42 Count
1762285303	350 Count	42 Count
1762283502	349 Count	42 Count
1762281701	348 Count	42 Count
1762279900	347 Count	42 Count
1762278100	346 Count	42 Count
1762276308	345 Count	42 Count
1762274507	344 Count	42 Count
1762272706	343 Count	42 Count
1762270905	342 Count	42 Count
1762269114	341 Count	42 Count
1762267304	340 Count	42 Count
1762265503	339 Count	42 Count
1762263702	338 Count	42 Count
1762261901	337 Count	42 Count
1762260100	336 Count	42 Count
1762258300	335 Count	42 Count
1762256499	334 Count	42 Count
1762254708	333 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)