APRS Track Direct

My position About ☰

reset

SR9BBC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9BBC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1750096517	433 Count	189 Count	188 Count
1750095616	429 Count	187 Count	186 Count
1750094715	426 Count	186 Count	185 Count
1750093813	419 Count	180 Count	179 Count
1750092912	416 Count	179 Count	178 Count
1750092011	412 Count	177 Count	176 Count
1750091110	410 Count	176 Count	175 Count
1750090209	407 Count	174 Count	173 Count
1750089308	403 Count	173 Count	172 Count
1750088407	400 Count	171 Count	170 Count
1750087505	396 Count	170 Count	169 Count
1750086604	392 Count	168 Count	167 Count
1750085703	388 Count	167 Count	166 Count
1750084802	377 Count	158 Count	157 Count
1750083901	374 Count	158 Count	157 Count
1750083000	372 Count	157 Count	156 Count
1750082099	369 Count	157 Count	156 Count
1750081198	366 Count	156 Count	155 Count
1750080298	363 Count	156 Count	155 Count
1750079397	361 Count	155 Count	154 Count
1750078495	358 Count	155 Count	154 Count
1750077594	355 Count	154 Count	153 Count
1750076693	352 Count	154 Count	153 Count
1750075792	349 Count	153 Count	152 Count
1750074891	346 Count	153 Count	152 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)