APRS Track Direct

My position About ☰

reset

REDMT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object REDMT. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786738659	138	83	255	97	80
1786735057	137	81	255	99	81
1786731454	138	79	255	100	82
1786727851	138	75	255	101	85
1786724249	138	73	255	103	86
1786720646	135	72	255	104	87
1786717043	129	70	255	104	88
1786713440	127	70	255	105	89
1786709838	127	70	255	104	88
1786706235	128	71	255	104	88
1786702632	128	72	255	103	87
1786699030	128	72	255	104	87
1786695427	127	73	255	103	86
1786691821	128	70	255	92	72
1786688573	128	74	255	102	86
1786684970	128	75	255	102	85
1786681365	129	75	255	101	85
1786677762	129	76	255	101	84
1786674159	130	76	255	100	83
1786670556	130	79	255	99	82
1786666953	132	82	255	97	80
1786663349	137	85	255	96	78
1786659746	137	86	255	95	77
1786656134	137	85	255	96	78

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)