APRS Track Direct

My position About ☰

reset

SQ5LTL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5LTL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1786728315	196 Count	979 Count
1786726514	195 Count	977 Count
1786724714	194 Count	975 Count
1786722914	193 Count	973 Count
1786721113	192 Count	971 Count
1786719314	191 Count	969 Count
1786717513	190 Count	968 Count
1786715714	189 Count	966 Count
1786713913	188 Count	965 Count
1786712113	187 Count	963 Count
1786710312	186 Count	956 Count
1786708513	185 Count	954 Count
1786706713	184 Count	952 Count
1786704915	183 Count	950 Count
1786703114	182 Count	948 Count
1786701314	181 Count	946 Count
1786699513	180 Count	944 Count
1786694111	177 Count	939 Count
1786692310	176 Count	937 Count
1786690514	175 Count	935 Count
1786688713	174 Count	929 Count
1786686912	173 Count	926 Count
1786685111	172 Count	923 Count
1786683313	171 Count	920 Count
1786681512	170 Count	917 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)