APRS Track Direct

My position About ☰

reset

SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790650367	7 Count	78 Count	3 Count
1790649767	6 Count	63 Count	3 Count
1790649166	4 Count	47 Count	2 Count
1790648565	2 Count	24 Count	1 Count
1790647965	1 Count	17 Count	1 Count
1790647364	116 Count	1012 Count	45 Count
1790646763	114 Count	993 Count	44 Count
1790646163	113 Count	981 Count	44 Count
1790645562	111 Count	965 Count	43 Count
1790644962	109 Count	944 Count	42 Count
1790644361	108 Count	934 Count	42 Count
1790643760	106 Count	914 Count	41 Count
1790643160	104 Count	891 Count	40 Count
1790642559	103 Count	882 Count	40 Count
1790641958	101 Count	866 Count	39 Count
1790641358	99 Count	847 Count	38 Count
1790640757	98 Count	835 Count	38 Count
1790640156	94 Count	820 Count	37 Count
1790639556	92 Count	801 Count	36 Count
1790638955	91 Count	791 Count	36 Count
1790638354	89 Count	775 Count	35 Count
1790637754	87 Count	756 Count	34 Count
1790637153	86 Count	746 Count	34 Count
1790636553	84 Count	732 Count	33 Count
1790635952	82 Count	714 Count	32 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)