APRS Track Direct

My position About ☰

reset

HS3UAA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS3UAA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1782552150	-43 dBm	14.05 V
1782551828	-42 dBm	14.05 V
1782551506	-42 dBm	14.07 V
1782551184	-42 dBm	14.05 V
1782550862	-43 dBm	13.99 V
1782550540	-42 dBm	14.07 V
1782550218	-44 dBm	13.99 V
1782549896	-43 dBm	14.05 V
1782549574	-42 dBm	13.99 V
1782549252	-42 dBm	14.07 V
1782548930	-41 dBm	14.05 V
1782548516	-42 dBm	13.99 V
1782548194	-42 dBm	14.05 V
1782547872	-44 dBm	14.05 V
1782547550	-42 dBm	14.05 V
1782546894	-42 dBm	14.05 V
1782546572	-41 dBm	14.07 V
1782546250	-42 dBm	14.05 V
1782545928	-42 dBm	14.05 V
1782545607	-42 dBm	14.05 V
1782545285	-42 dBm	14.03 V
1782544962	-41 dBm	14.05 V
1782544327	-41 dBm	14.05 V
1782544006	-44 dBm	14.05 V
1782543683	-41 dBm	14.05 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)