APRS Track Direct

My position About ☰

reset

N6PAZ-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N6PAZ-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RFIn*	Temp*
1786726056	35 Pkts	24 C
1786725456	18 Pkts	22 C
1786724856	22 Pkts	22 C
1786724256	20 Pkts	21 C
1786723656	19 Pkts	21 C
1786723056	23 Pkts	20 C
1786722456	24 Pkts	19 C
1786721862	26 Pkts	19 C
1786721256	26 Pkts	18 C
1786720656	24 Pkts	17 C
1786720056	28 Pkts	17 C
1786719456	33 Pkts	16 C
1786718856	25 Pkts	16 C
1786718256	20 Pkts	15 C
1786717656	21 Pkts	15 C
1786717056	20 Pkts	14 C
1786716456	19 Pkts	14 C
1786715856	18 Pkts	13 C
1786715256	17 Pkts	13 C
1786714656	17 Pkts	13 C
1786714056	18 Pkts	13 C
1786713456	16 Pkts	13 C
1786712856	18 Pkts	13 C
1786712256	18 Pkts	13 C
1786711656	16 Pkts	13 C

*Used Equation Coefficients:

RFIn: 0, 1, 0

Temp: 0, 1, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)