APRS Track Direct

My position About ☰

reset

SP4SR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4SR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766212101	287 Count	39 Count
1766206705	280 Count	39 Count
1766204905	279 Count	39 Count
1766203104	278 Count	39 Count
1766201304	277 Count	39 Count
1766199503	276 Count	39 Count
1766197702	275 Count	39 Count
1766195902	274 Count	39 Count
1766194101	273 Count	39 Count
1766190500	271 Count	39 Count
1766188706	266 Count	39 Count
1766185104	264 Count	39 Count
1766183304	263 Count	39 Count
1766181503	262 Count	37 Count
1766179703	261 Count	36 Count
1766177902	260 Count	36 Count
1766174300	258 Count	35 Count
1766170699	256 Count	30 Count
1766168899	255 Count	30 Count
1766167104	250 Count	26 Count
1766165304	249 Count	26 Count
1766163503	248 Count	26 Count
1766161703	247 Count	21 Count
1766158103	245 Count	21 Count
1766156303	244 Count	21 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)