APRS Track Direct

My position About ☰

reset

SP2PA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2PA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766207191	292 Count	537 Count	145 Count
1766205390	289 Count	534 Count	143 Count
1766203589	286 Count	531 Count	141 Count
1766201788	283 Count	527 Count	139 Count
1766199987	281 Count	525 Count	138 Count
1766198186	278 Count	517 Count	136 Count
1766196385	276 Count	515 Count	135 Count
1766194595	274 Count	513 Count	134 Count
1766192794	271 Count	509 Count	132 Count
1766190993	268 Count	505 Count	130 Count
1766189192	265 Count	501 Count	128 Count
1766187391	263 Count	497 Count	127 Count
1766185590	260 Count	491 Count	125 Count
1766183789	257 Count	487 Count	123 Count
1766181988	255 Count	484 Count	122 Count
1766180187	253 Count	480 Count	121 Count
1766178386	251 Count	477 Count	120 Count
1766176585	250 Count	474 Count	120 Count
1766174784	249 Count	473 Count	120 Count
1766172994	248 Count	470 Count	120 Count
1766171193	247 Count	468 Count	120 Count
1766169392	246 Count	467 Count	120 Count
1766167591	245 Count	466 Count	120 Count
1766165790	244 Count	466 Count	120 Count
1766163989	241 Count	464 Count	118 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)