APRS Track Direct

My position About ☰

reset

KC1VSR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC1VSR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RFIn*	RFiGate*	DigiRpt*	Temp*
1766205568	74 Pkts	74 Pkts	51 Pkts	21 C
1766198368	70 Pkts	70 Pkts	42 Pkts	22 C
1766191167	89 Pkts	89 Pkts	46 Pkts	22 C
1766183967	79 Pkts	78 Pkts	42 Pkts	22 C
1766176769	74 Pkts	74 Pkts	42 Pkts	22 C
1766169568	59 Pkts	59 Pkts	38 Pkts	22 C
1766162368	53 Pkts	53 Pkts	40 Pkts	22 C
1766155168	52 Pkts	52 Pkts	40 Pkts	22 C
1766147968	73 Pkts	73 Pkts	45 Pkts	22 C
1766140768	69 Pkts	65 Pkts	48 Pkts	22 C
1766133568	76 Pkts	76 Pkts	44 Pkts	22 C
1766126368	126 Pkts	120 Pkts	45 Pkts	22 C

*Used Equation Coefficients:

RFIn: 0, 1, 0

RFiGate: 0, 1, 0

DigiRpt: 0, 1, 0

Temp: 0, 1, 0

InetiGate: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)