APRS Track Direct

My position About ☰

reset

EB5BZM-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1763237299	0 Count	43 Count
1763235258	0 Count	43 Count
1763233219	0 Count	43 Count
1763231176	0 Count	20 Count
1763229135	0 Count	16 Count
1763227094	0 Count	16 Count
1763226410	0 Count	16 Count
1763224369	0 Count	2 Count
1763222328	0 Count	2 Count
1763220288	0 Count	2 Count
1763218246	0 Count	2 Count
1763216205	0 Count	2 Count
1763214164	0 Count	2 Count
1763212122	0 Count	2 Count
1763210082	33 Count	1010 Count
1763208041	33 Count	995 Count
1763206000	33 Count	994 Count
1763203959	33 Count	982 Count
1763201918	33 Count	956 Count
1763199877	33 Count	901 Count
1763197836	33 Count	894 Count
1763195796	33 Count	887 Count
1763193755	33 Count	887 Count
1763191714	33 Count	887 Count
1763189673	33 Count	887 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)