APRS Track Direct

My position About ☰

reset

LW2DHT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790658439	21 Count	16 Count	15 Count
1790656636	15 Count	11 Count	11 Count
1790654833	10 Count	7 Count	7 Count
1790653029	1013 Count	561 Count	481 Count
1790651225	996 Count	556 Count	477 Count
1790649422	981 Count	552 Count	473 Count
1790647619	977 Count	549 Count	470 Count
1790645815	969 Count	543 Count	465 Count
1790644012	948 Count	536 Count	458 Count
1790642209	941 Count	531 Count	454 Count
1790640448	935 Count	527 Count	450 Count
1790638644	926 Count	523 Count	446 Count
1790636841	910 Count	520 Count	443 Count
1790635038	897 Count	515 Count	439 Count
1790633234	889 Count	512 Count	436 Count
1790631431	884 Count	508 Count	432 Count
1790629628	879 Count	503 Count	428 Count
1790627824	872 Count	496 Count	422 Count
1790626020	867 Count	491 Count	418 Count
1790624217	861 Count	485 Count	413 Count
1790622414	855 Count	479 Count	408 Count
1790620610	849 Count	474 Count	403 Count
1790618846	844 Count	469 Count	399 Count
1790617043	839 Count	465 Count	395 Count
1790615240	834 Count	460 Count	391 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)