APRS Track Direct

My position About ☰

reset

PU5SZN-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PU5SZN-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1762342310	135	80	80	138	137
1762342009	135	80	80	137	137
1762341709	135	80	79	137	137
1762341405	134	80	79	137	136
1762341104	134	79	79	136	136
1762340802	134	80	79	136	136
1762340503	132	79	78	135	135
1762340201	133	79	78	135	135
1762339600	132	79	78	135	135
1762339301	132	78	78	134	134
1762338397	130	78	77	133	129
1762338096	131	78	77	134	129
1762337796	131	78	78	134	129
1762337495	130	77	77	133	128
1762337194	128	77	76	131	127
1762336894	127	76	75	130	127
1762336292	127	76	75	130	127
1762335991	128	76	76	131	127
1762335691	127	76	75	130	127
1762335391	126	75	75	129	127
1762335090	125	74	74	128	127
1762334792	125	78	77	128	127
1762334490	124	77	76	127	127
1762334189	122	76	75	125	125
1762333889	122	76	75	125	125

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)