APRS Track Direct

My position About ☰

reset

IZ1DME-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ1DME-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	RSSI*	VBAT*
1790659368	-94 dbm	2.34 V
1790657869	-95 dbm	2.35 V
1790656368	-95 dbm	2.37 V
1790654868	-95 dbm	2.38 V
1790653369	-95 dbm	2.4 V
1790651882	-94 dbm	2.41 V
1790650368	-95 dbm	2.42 V
1790648869	-95 dbm	2.43 V
1790647369	-96 dbm	2.45 V
1790645870	-96 dbm	2.46 V
1790644369	-96 dbm	2.47 V
1790642869	-95 dbm	2.49 V
1790641368	-96 dbm	2.5 V
1790639869	-96 dbm	2.51 V
1790638368	-96 dbm	2.53 V
1790636869	-95 dbm	2.54 V
1790635369	-96 dbm	2.55 V
1790633868	-95 dbm	2.57 V
1790632368	-96 dbm	2.58 V
1790630874	-94 dbm	2.59 V
1790629369	-94 dbm	2.61 V
1790626408	-95 dbm	2.64 V
1790623378	-90 dbm	2.68 V
1790618869	-90 dbm	2.73 V
1790615871	-91 dbm	2.76 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)