APRS Track Direct

My position About ☰

reset

SM7TNO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM7TNO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Volt*	Ampere*
1779764197	13.4 V	74 A
1779762381	13.4 V	74 A
1779760570	13.4 V	74 A
1779758755	13.4 V	74 A
1779756939	13.4 V	74 A
1779755124	13.4 V	74 A
1779753309	13.4 V	74 A
1779751498	13.4 V	74 A
1779749683	13.4 V	74 A
1779747865	13.4 V	74 A
1779746049	13.4 V	74 A
1779744234	13.4 V	74 A
1779742419	13.4 V	74 A
1779740612	13.4 V	74 A
1779738786	13.4 V	74 A
1779736971	13.4 V	74 A
1779735156	13.4 V	74 A
1779733338	13.4 V	74 A
1779731523	13.4 V	74 A
1779729708	13.4 V	74 A
1779727892	13.4 V	74 A
1779724261	13.4 V	74 A
1779722446	13.4 V	74 A
1779718820	13.4 V	74 A
1779717001	13.4 V	74 A

*Used Equation Coefficients:

Volt: 0, 1, 0

Ampere: 0, 1, 0

Batt: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)