APRS Track Direct

My position About ☰

reset

SM0YOS-8 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0YOS-8. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value5*
1786729114	125	126	129	122
1786725514	133	135	129	129
1786721915	124	126	129	122
1786718315	133	134	129	129
1786714715	133	134	129	129
1786711115	124	126	129	121
1786707260	142	144	145	139
1786707178	142	144	144	139
1786707098	142	144	144	139
1786707030	142	144	145	138
1786706890	142	144	139	138
1786706825	142	144	139	138
1786706674	142	144	138	139
1786706601	142	144	138	138
1786706419	142	144	139	139
1786706347	142	144	139	139
1786706243	142	144	138	138
1786706139	142	144	139	138
1786706060	142	144	139	138
1786705939	136	138	139	132
1786705866	142	144	139	138
1786705794	142	144	138	138
1786705644	142	144	139	139
1786705538	142	144	139	138
1786705459	142	144	139	138

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)