APRS Track Direct

My position About ☰

reset

XE2G-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2G-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1778047593	137	28	999	361	298
1778041600	137	27	999	364	304
1778038604	137	28	999	361	297
1778035608	137	28	999	358	294
1778032611	137	29	999	354	288
1778029615	137	31	999	347	279
1778026619	137	33	999	335	265
1778023622	137	35	999	313	258
1778020626	137	36	999	324	252
1778017629	137	36	999	325	256
1778014633	137	36	999	324	255
1778011637	136	35	999	328	261
1778008640	137	34	999	331	263
1778005643	136	34	999	333	266
1778002647	136	33	999	319	266
1777999649	136	32	999	326	272
1777996653	136	30	999	349	283
1777993657	136	29	999	355	292
1777990661	136	28	999	347	300
1777987664	136	25	999	373	312
1777984668	137	23	999	381	321
1777975680	137	23	999	383	324
1777972683	136	22	999	384	325
1777969687	136	23	999	383	323
1777963695	136	22	999	372	327

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)