APRS Track Direct

My position About ☰

reset

SP2OSA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1836274461	809 Count	89 Count	61 Count
1782508741	406 Count	89 Count	40 Count
1782507840	404 Count	86 Count	39 Count
1782506939	403 Count	86 Count	39 Count
1782506038	402 Count	84 Count	39 Count
1782505137	401 Count	83 Count	39 Count
1782504236	400 Count	81 Count	39 Count
1782503335	399 Count	81 Count	39 Count
1782502457	398 Count	81 Count	39 Count
1782501556	397 Count	81 Count	39 Count
1782500655	396 Count	81 Count	39 Count
1782499754	395 Count	80 Count	39 Count
1782498853	394 Count	79 Count	39 Count
1782497952	393 Count	79 Count	39 Count
1782497051	392 Count	79 Count	39 Count
1782496150	391 Count	79 Count	39 Count
1782495249	390 Count	79 Count	39 Count
1782494348	389 Count	79 Count	39 Count
1782493447	388 Count	79 Count	39 Count
1782492547	387 Count	79 Count	39 Count
1782491645	386 Count	79 Count	39 Count
1782490745	385 Count	79 Count	39 Count
1782489844	384 Count	79 Count	39 Count
1782488943	383 Count	79 Count	39 Count
1782488042	382 Count	79 Count	39 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)