APRS Track Direct

My position About ☰

reset

F4HUO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4HUO-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1778027860	512 Count	56 Count	23 Count
1778024259	510 Count	56 Count	23 Count
1778020657	508 Count	56 Count	23 Count
1778017063	506 Count	56 Count	23 Count
1778013461	504 Count	56 Count	23 Count
1778009860	502 Count	56 Count	23 Count
1778006259	500 Count	56 Count	23 Count
1778002657	498 Count	55 Count	23 Count
1777999056	496 Count	55 Count	23 Count
1777995463	494 Count	54 Count	23 Count
1777991861	492 Count	53 Count	23 Count
1777988260	490 Count	53 Count	23 Count
1777984658	488 Count	53 Count	23 Count
1777981057	486 Count	53 Count	23 Count
1777977456	484 Count	53 Count	23 Count
1777973862	482 Count	52 Count	23 Count
1777970260	480 Count	46 Count	23 Count
1777966659	478 Count	42 Count	23 Count
1777963057	476 Count	42 Count	23 Count
1777959456	474 Count	42 Count	23 Count
1777955855	472 Count	42 Count	23 Count
1777952261	470 Count	38 Count	23 Count
1777948659	468 Count	36 Count	23 Count
1777945058	466 Count	35 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)